Radio Frequency Press Type SL36x60

PrintE-mail

RfsProtech SL 36 x 60 (915 x 1524 x 50 mm)

this press has never been in production and has only been used at trade shows.  With less than 5 hrs of run time this machine comes with new warranty and is a priced to sell at a discounted price.

Machine Description:

An economical, high quality edge gluer with the platen mounted on a 45" angle for easy loading and placement of stock within the press. The small foot print of the press saves on space and makes ideal for small just in time jobs to large orders. The press features pneumatic pressure on the edge of the panel to close the joints; and a 6KW RfsProtech Generator to rapidly cure the glue joints. The press is complete with all required safety circuits and controls required for safe operation. The ergonomics of the press, the control over stock placement, and the affordable price; all these features have made the Model SL the favorite workhorse for users from the smallest shops to the largest woodworking companies.


Press Specifications:

  1. Curing area: 36" x 60" x 2" thick. (915 x 1524 x 50 mm )
    Clamping pressure is applied by multi-power (dual pistons on a common shaft) pneumatic cylinders to maximize pressure while relying on standard plant pressures. Unlike presses without multi-power cylinders, which require booster compressors, the Model SL 36 x 60 (915 x 1524mm) reaches full capacity at 100-psi (7 Bar) plant air pressure.
  2. Edge pressure is applied by eight (8) each pusher shoes, each with a 4" bore x 4" (100 x 100 mm) stroke twin-piston multi-power pneumatic cylinders.
  3. Top platen pressure is applied by two (2) 5" diameter x 16" (125 x 406 mm) stroke pneumatic cylinders that keeps the footprint to a minimum while still allowing the operator full access to the platen area.
  4. The platen is set at a 45-degree angle and the top platen opens wide; allowing the operator to step inside the press for ergonomic and accurate parts placement.
  5. The internal solid state RfsProtech 6kW Generator cures approximately 600 square inches of glue line per minute. (2580 cm²)
  6. The Generator features solid state rectifiers and all aluminum cabinet for maximum conductivity and superior performance.
  7. Two-hand no-tie-down safety controls for closing the top platen.
  8. Controls are simple to understand, and are complete with the required push-buttons, switch, meters, digital operator display, and on-screen troubleshooting diagnostics.
  9. The machine is controlled by a PLC for dependability and efficient maintenance.
  10. All controls will be provided for safe and efficient operation.
  11. The operator screen permits efficient operation, and the included press diagnostics screens assist in trouble-shooting when the need arises.
  12. Proper interfaces will be provided for operational signals and emergency system stop.
  13. All necessary RF controls, including buttons, meters, and PLC operator interface panel are mounted on a control panel attached to the left front of the press.
  14. Interlocked top platen and safety switches on all access doors insure operator safety.
  15. Power requirements are 460 volt, 60 cycle, 3 phase electric unless otherwise specified.
  16. Circuit breaker protection is provided. A service disconnect is required for safety, but is not provided.