Radio Frequency Press type Door Clamp

About the Radio Frequency Press type Door Clamp Model 4-5

A high quality 4-way clamp with its 38" by 78" clamping area mounted on a 45° angle for easy loading, positioning and removal of stock. The press features pneumatic pressure for the 4-way clamping of doors and panels. An internally mounted RfsProtech Radio Frequency Generator cures the glue joints in seconds. Complete with all controls and necessary safety devices. The machine is equipped with ball screw spindles for fast setup of different size panels.

Specifications of the Radio Frequency Door Clamp Model 4-5

• The heavy welded steel frame is computer designed to minimize deflection under full working pressures.
• Clamping Area is 38" x 78" x 1 ¼” thick.
• Clamping pressure is applied by pneumatic cylinders to maximize pressure while requiring only plant line pressure (no booster compressors).
• Edge and end pressure applied by 1" bore x 2" stroke pneumatic cylinders.
• Each cylinder fitted with a shut-off valve for ease of use.
• Side and end pressure each feature separate controls which allow independent positioning, alignment powered by electric motors.
• Platen set at a 45° angle for easy access to the platen for placement, alignment and removal of stock.
• The internal solid state RfsProtech RF Generator can cure door/window joints in seconds.
• The generators (four) feature a solid state rectification, state-of-the-art design, and an aluminum cabinet for maximum efficiency and performance. Each generator is connected to a corner for quick curing. Each corner has a unique machined corner fixture to allow the RF to travel the length of the glue joint. This process heats and accelerates the evaporation of water from the glue.
• Operator controls for opening/closing of clamp is mounted on a floor mounted pedestal. Safety light curtains will automatically shut-off the RF generator if the beam is broken during the cure cycle.
• Controls are easy to understand, and feature a digital operator interface with messaging for operation and troubleshooting.  Controls include all required timers, meters, switches and push-buttons for full control of the press.
• Control panel mounted on the left side of the press, unless otherwise specified.
• Wired for 480 Volt 60 Cycle 3 Phase operation.  Other voltages available, please specify.
• Circuit breaker protection is provided.  A service disconnect is required for safety, but is not provided.